For Rox Polestones 01 2023 2024 2025 2026 Electrostatic Adsorption Skylight Sunshades UV Protection Heat insulation Accessories

For Rox Polestones 01 2023 2024 2025 2026 Electrostatic Adsorption Skylight Sunshades UV Protection Heat insulation Accessories

Precautions
Note: Be sure to place the sunroof (glass) in the sun to heat it up for bonding. First wipe the glass and film clean with a wet towel, then dry it with a towel, and finally use an adhesive to remove the dust on it.

Installation tutorial:

Step 1:
After receiving the goods, open the sun visor and wipe the smooth side with a wet towel. Then wipe the car sunroof glass with a wet towel to clean the dust and dirt, then dry it with a dry towel, and finally use an adhesive to clean the dust on it.
Step 2:
It is best to install it with more than two people. Paste the smooth side of the static sun visor to the sunroof. Be careful to flatten the edges first. Pay attention here (the 3-5mm edge around the integrated sunroof visor is larger), and then stick it smoothly along the way.
Step 3:
After pasting, check where there are bubbles and push the bubbles to the edge with a scraper.
Note that if there are creases, they can be ignored. The creases of the sunshade will slowly return to flatness after heating.
Step 4:
After pasting, observe whether it will fall off in about half an hour. If it falls off, it means that there are still bubbles and the installation is not firm. After the split skylight is installed, please do not open or close the skylight immediately. It needs to be kept for more than three hours for the best effect.